Tag Archives: box

photo of trailer front with box mounted

More Storage – A Trailer Tongue Box

Jim, May 17:

photo of the bare trailer tongue

Bare trailer tongue

During the Big Bend trip, I started to think about refining our trailer and realized that storing jacks and other trailer equipment in the galley complicated our setup. A second storage area would make the galley more convenient and allow Marilyn to start our evening meal while I was setting up camp. I had seen boxes that mount on a trailer tongue, and thought that might be the answer. They aren’t hard to find, and I soon had one on order. Made by Better Built, and 34-inches by 19-inches and 18-inches high, it looked like it would just fit on our teardrop’s small tongue.

The new trailer tongue box

The new trailer tongue box

In hand a few days later, it looked great and didn’t weigh much — welded aluminum construction with a locking latch and power-assisted top hatch. Our trailer has a single rail for the tongue however, and it looked like the box was better suited to trailers with a “y” front hitch. Mounting the soft aluminum box on a single rail seemed like a problem — the first time it was leaned upon, it would bend. I decided to get some help from my friends at Vintage Motor to make a stout steel mount. Jason and I quickly decided  to cradle the front and back bottom edges with 1 1/2-inch angle iron. These would be welded to other angle iron and attached to the 2 by 3-inch trailer tongue with bolts.

We set to work. After measuring the front and back box edge, Jason cut 16 and 34-inch pieces of 1 1/2-inch angle iron on a chop saw. By placing them under the front and back edge, we were able to mark the precise size and angle using a sharpie. Using these marks, he was able to trim the rails with a pneumatic cut-off tool, and round the rough edges with an angle grinder.

Next, we cut brackets and holes and drilled them to accept the tongue bolts. They were then welded to the rails. There was one bracket per rail, and they were placed so that the rails would be centered on the trailer tongue with a bracket on each side. Finally we drilled four holes on the long rail, and two holes on the short one to mount the box.

Rails and brackets complete, it was time for a test fit. Everything seemed to work, so I set about drilling bolt holes into the trailer tongue. This is very tough steel, and it took awhile — even with the help of my grandad’s 1/2-inch drill. Now we could bolt the rails on, and set the box into them. Last, we drilled holes from the bottom, through the rails, and into the box. It was secured with six bolts as well. We’d had to “fudge” the fit to straighten to box and allow for lid clearance with the trailer, so the front rail was a little off-center. A trip back to the shop to adjust it’s length, and we were ready for paint.

Now painted, it was time for the final installation. To protect the bottom from being dented, I’ll cut a piece of plywood to fit the inside. The box size seems proportional to the trailer — a lucky break. I was also pleased to see that the diamond plate on the trailer matches the box, both in pattern and rising to about the same height as the diamond plate on the trailer. Looks like a custom fit!