Jim, July 31:

The new storage box and galley table would certainly improve our setup and strike time, but I was sure it could be improved a little more. When we drive into a campsite, one of the first jobs is to level the trailer. Up to now, I used two scissor jacks (one under each rear corner of the trailer) and that worked well enough. Scissor jacks are fiddly and can be hard to use. They certainly aren’t quick. The light-weight jacks had to be extended by hand until they could be wedged under the trailer because they would “dance around” while turning the adjustment screw. They couldn’t be stored under the trailer. I thought we could do better.

Atwood Stabilizer Jack — Deployed

Looking around at other RVs, I learned about a “stabilizer jack”. Intended for leveling a trailer and designed to store under it, they seemed to fit the bill. A quick cruise on Amazon, and we had a candidate — the Atwood 82301stabilizer jack. I ordered a set of three. One for the tongue and one for each rear corner.

The Atwood stabilizer jacks can be either bolted or welded onto the trailer. My friend Jason at Vintage Motor Car agreed that welding would be best. A day or two later, they were installed. A little black spray paint, and the job was done.

Atwood Stabilizer Jack — Retracted

The jacks hide under the trailer when not in use, and only take a couple inches of ground clearance. Deployment is easy. Pull into the site, swing the two rear jacks down into the locked position and then deploy the front stabilizer jack the same way. The trailer sits pretty low to the ground, so occasionally I dig a little ground out from under the jack before it swings into place.

Jack handle in use

The final step is using the steel handle to adjust each jack’s height while watching a bubble level. The recommended jack handle (purchased separately) is rather short and will only install in the jack if all the holes are perfectly aligned — not always the case. A “heel” pry bar with a tapered end is both longer and will work with less perfectly aligned holes. The 16-inch pry bar (purchased in a set of four for $12 from a Red Power Roundup tool vendor) was the perfect size. Amazon has a similar product from about $25.

Pry Bar Set

Each stabilizer jack has a 650-pound work capacity and a 1000-pound support capacity. They measure 11 1/2-inches retracted and extend to 17 3/4-inches. I carry an assortment of wood blocks from 1/2-inch to 3 1/2-inches in thickness to account for sloping campsites. Also, I carry one scissors jack for unforeseen circumstances from pulling a stuck trailer hitch to changing a tire. That satisfies my “belt and suspenders (and belt)” approach. So far, we’ve been able to meet every camping challenge!

Pry Bar vs. Atwood jack handle